How To Add Lights Under Cabinet In Kitchen
Camila Farah
Ream the cut end of the flex to remove burrs and install flex connectors on both ends.
Of flex where it enters the walls. To effectively hide cords mount lights toward the front edge of cabinets. Drill a pilot hole with 1 16 inch drill bit 5 8 inches deep. Lighting kits are available for retrospective fitting to units.
Kit for fitting under kitchen wall unit lighting the easiest way to fix under unit lighting after wall units are fitted is to buy battery operated lights which either screw up to or stick on to the underside of the units. Learning how to install under cabinet lighting is something any homeowner can do. These lights can be bought from most diy stores. Slide lights onto exposed screws and lock in place.
Be sure to use the included fasteners whenever possible. Hold the light in place near the front of the cabinet then mark 1 inch from each end of the light with a pencil. Using a drill or screwdriver fasten the light directly to the bottom of the cabinets. See how to add two different types of undercabinet lighting.
RELATED ARTICLE :
- kitchen designs dark wood cabinets
- kitchen design antique white cabinets
- kitchen cover carved cabinet door
Using your kitchen lighting layout plan to mark out exactly where the under cabinet light bars will mounted. Holes through the cabinet sides and run 1 2 in. Most under cabinet light fixtures come with the perfect size of screw included in the packaging. Run power cords under the cabinet or along wall trim up to a point directly above the outlet leaving just enough slack to go straight down to the outlet.
Find the center and mark it with a pencil. Flex for each light or group of lights for the switch and for the power photo 4 and figure a. Make over your kitchen lighting with easy under cabinet lighting. Cords can be fastened under cabinets with small cable clamps or with adhesive such as epoxy or dabs of hot glue.
This involves running a new cable to a new switch box that you need to install and then pulling cable from the switch to where each fixture will be located. The easiest way to get power for the hard wired under cabinet system is to tap into the power in a nearby receptacle. Insert mounting screws and tighten with the phillips screwdriver leaving 1 8 inch of the screw thread exposed. Figuring out where to run the cables to the fixtures can be tricky.
View Video For How To Add Lights Under Cabinet In Kitchen
View Video Review
Source : pinterest.com
Another Post:
